How to Use the Come Sit Stay Training Kit for Obedience

Quick answer

Use the EzyDog Come Sit Stay Training Kit to teach your dog basic obedience commands through positive reinforcement, combining a front-clip harness, no-pull leash, clicker, and treat pouch for consistent, distraction-free sessions.

Step-by-step obedience training with the Come Sit Stay Training Kit

1. Step 1: Set up the harness and leash: Fit the X-Link Dog Harness snugly around your dog's chest and back, ensuring the front clip is centered. Attach the Zero Shock Leash to the front D-ring. This setup discourages pulling and keeps your dog facing you during training. Check that the harness is not too tight—you should be able to slide two fingers between the strap and your dog's body.
2. Step 2: Prepare the clicker and treats: Load the SnakPak Treat Bag with small, soft treats your dog loves. Wear the bag on your belt or waistband. Place the Command Clicker on your index finger so you can click with a thumb press. Use treats that are pea-sized to avoid overfeeding during a session.
3. Step 3: Charge the clicker (conditioning): In a quiet room, click the Command Clicker and immediately give your dog a treat. Repeat 10–15 times until your dog looks at you expectantly when they hear the click. This teaches the clicker means a reward is coming. Do not skip this step—without conditioning, the clicker has no meaning for your dog.
4. Step 4: Teach the 'Sit' command: Hold a treat in front of your dog's nose, then slowly move it upward and slightly back over their head. As your dog's bottom touches the floor, say 'Sit,' click the Command Clicker, and give the treat. Repeat 5–10 times. If your dog jumps for the treat, you are moving the treat too high—keep it low and slow.
5. Step 5: Practice 'Come' on a loose leash: With your dog on the Zero Shock Leash, back away a few steps, say 'Come,' and gently guide them toward you using the front-clip harness. When they reach you, click and treat. Gradually increase the distance. Never yank the leash—the front-clip design works best with light, consistent pressure.
6. Step 6: Add the 'Stay' command: Ask your dog to sit, then hold up your palm and say 'Stay.' Take one step back. If your dog stays seated, click and return to reward. If they move, reset and try again with a shorter distance. Keep initial stays very short (2–3 seconds) to build confidence before increasing duration.

Product facts

• Come Sit Stay Training Kit: Bundle includes X-Link Dog Harness (front-clip, reflective no-pull design), Zero Shock Leash, Command Clicker, and SnakPak Treat Bag. Each component serves a specific role in obedience training: the harness gives you control without choking, the leash absorbs jerks, the clicker marks correct behavior, and the treat bag keeps rewards handy.